Solid State batteries need high operating pressure to maintain solid-to-solid contact and suppress lithium dendrite formation. Two Tekscan 5076 pressure mapping sensors were used to monitor the pressure acting on the cell.
In order to measure the pressure acting on the cell, the sensors were placed between the cell and the homogenization pads. The pressure mapping sensors were selected because they enabled the assessment of the effective cell pressure in the cell fixture without altering the overall fixture deflection, as opposed to thicker load cells. Pressure-sensitive films were not utilized as they only allow the measurement of the maximum pressure and were therefore unsuitable for judging the later-described pressure differences between load scenarios.
Read the full article published by Lovis Wach, Constantin Ruess, Sophie Grabmann, and Ruediger Daube at TUMint.Energy Research GmbH.