How do I connect a FlexiForce sensor after it has been trimmed?

Question: How do I connect a FlexiForce sensor after it has been trimmed?

 

Answer: If Tekscan trims the A201 sensors to two inches, four inches, or six inches, the sensor will come with three (3) male square pin connectors spaced at 0.1" (2.54mm). If you trim the sensor yourself, you will need to re-connect the sensor using one of two methods.  You can purchase staked pin connectors and a crimping tool, or you can use a conductive epoxy to adhere small wires to each conductor.

Did this Article Solve your Issue?

If you did not find a complete solution to your problem, please let us know by filling out the following form or calling us directly.

Tekscan Technical Support Hours
Monday - Friday: 8:00am - 7:00pm EST, Excluding Holidays

To Reach Tekscan Technical Support

Call (800) 248-3669 x359 Toll Free within the US and Canada.
Call 1(617) 464-4500 x359 International
Call 1(617) 464-4266 International
Email: support@tekscan.com

We respond promptly to customer problems, and new support articles are created from your input.

Name: Email:
* Hardware Serial #: ** Software Serial #:
Describe your Issue:


Mollom CAPTCHA


Please enter the value of the security question above.



* - The software serial number can be found in the Help drop down menu of the program. Navigate to Help -> About.

** - The hardware serial number can be found on the back of each Handle/Cuff/Hub preceded by S/N.